Build A Low Budget Paint Stand
by larry meyer
This is a sketch of the plans below followed by pictures with brief description on same.(i can build a model better than i can draw (-:)
Use a drill bit thats the same size as your coat hanger.Drill these holes about 1/2" deep. After placing bent coat hanger in holes use 5 min. epoxy to glue in place.
Now you can pull wire apart & drop body to inside of wire. The more you bend the wire back,the tighter the wire holds the body. This can also be used to decal the body without any fear of damaging a decal or getting oil from your fingers on the body.
materials list:
2-coat hangers
12-toothpicks
block of wood
5 min. epoxy
drill & bits
ruler